Garage Door Remote Is Not Working Consistently

You may be wondering why your overhead door remote is not working consistently.

Garage door remote problems are common but don’t panic. They can be fixed right away.

After all, garage doors are used all the time, and it’s no wonder if there can be issues with the system.

Moreover, this article will discuss different reasons why your garage door remote is not working consistently and how you can solve the problems.

Why is my remote not working consistently?

It’s convenient to have a remote on overhead doors.

By simply clicking it, you can open or close the door. However, it is prone to damage.

A malfunctioning remote can happen due to a lot of reasons.

Since it is an electrical device, it’s no wonder some issues can happen to the remote.

If it’s affecting the operation of your door, check the remote.

Also, observe these signs why your garage door remote is not working consistently.

Disrupted Signal

The signal communicates between your remote and the opener so you can open and close the door.

However, there are cases there are disruptions in the signal.

If the garage door remote is out of range or if the antenna is damaged, it can cause interference in the signal.

First, check the signal in your remote. Then, press the button if the remote is working.

If it’s not working, you can replace the battery and test it once again.

On the other hand, if there is damage to the antenna, replace it right away.

Aside from replacing, you can also add an antenna extension to increase the range of your opener.

For the installation of the antenna extension, watch this.

Also, you can ask a garage door repair company near you for an antenna installation guide.

Dead Batteries

The most common issue of failing remote is dead batteries.

If you replaced the battery years ago, it’s time to buy a new one.

Also, buy an established battery brand for a longer-lasting battery.

Hence, avoid discounted or cheap batteries as they have a shorter life.

However, if changing the battery doesn’t solve your remote issue, you need to check the battery contacts.

Damaged Battery Contacts

Dirty or molded contacts inside the battery can prevent the current flow of the circuit board, which can hinder the remote’s operation.

If the contacts are wet or discolored, you need to dry and polish them before placing the battery.

You can polish the contacts by using 400-grit sandpaper or fine steel wool.

Engaged Lock Feature

Homeowners may accidentally tap the lock feature on the control panel when they’re cleaning.

A disengaged lock will prevent the opener to respond to the remote.

To fix this problem, click the lock button to disengage. Then, test the remote if it’s working again.

If this method does not work, there might be a problem with the remote system.

System Needs a Reboot

If you still find your door challenging to open or close, check your garage door’s wiring remote and the receiver.

Consider a remote control as small computers.

A remote has circuit boards to allow the operation.

Sometimes, you need to reset the remote to fix the problems.

To reboot the system, remove the batteries and install them after 30 seconds.

Then, check the remote if it’s working normally again.

System Needs Reprogramming

If you still find the garage door difficult to open or close, there must be a problem with the wiring of your garage door remote and the opener’s control board.

To solve this problem, follow the steps below:

  1. Disconnect the garage door opener from the outlet.
  2. Detach the wires from the motor.
  3. Then, reconnect the machine to power.
  4. Reprogram the remote control by tweaking it into the opener program. You can watch this video for the process.
  5. Unplug the opener once again and reconnect the wiring to the motor.
  6. Finally, test the remote if the door operates.

Need assistance?

When you find out your garage door remote is not working consistently after doing the troubleshooting steps, contact Garage Door Pitt to help you.

Garage door remotes are electric devices that require knowledge on fixing the problem.

If you leave the job to us, we will inspect the problem and fix it.

What are you waiting for? Call our team in Pittsburgh to receive our high-quality 24/ 7 garage door repairs!

Rate this post
Michael Williams

Michael Williams

Over a decade in the garage door business has taught me that the most professional way to go is transparency with my clients. Why charge clients when they can clearly solve some of their garage trouble DIY? In this blog I will share as much as I can. If you still need help, don't hesitate to call!